Turn any preamp into a full tube stack
A full 125 watts of pure tube power at your disposal. The perfect match for the Vidur bass preamp, but designed to be compatible with any preamp on the market. Bass or otherwise. This no-nonsense powerhouse might look inconspicuous on the outside, but it’s packed with innovations to make it the most user friendly and maintenance free tube power amp in the world.
Automated bias – rockSteady
You’ll never have to bring in your amp for servicing. Instead of having the bias voltage for the power tubes checked every few months, the Detti amps will do this several times per second(!), and adjust if necessary. This will ensure a rock solid and consistent sound, especially in the low end, longer tube lifespan, saves the costs for regular servicin, plus, the knowledge your amp is always working at peak performance.
Replacing the tubes is now a breeze as well. Out with the old, in with the new and you’re done. rockSteady bias will also notify you when the tubes are at the end of their usable lifespan.
No more mythical standby switch
The standby switch as found on many tube amps might be one the most misunderstood and misinterpreted controls within the realm of musical equipment. It did have it’s place in the previous century, but no longer needed. Misuse might even cause harm to an amp. Every technical shortcoming the old standby switch had to omit, has been overcome in the Detti series power amps. Standby switch, gone.
When laying down the low end, your putting some serious mechanical energy into your speaker. It’s an amplifier’s job to take control tight over any free will the speaker might exhibit. Vintage tube amps relied on sealed speaker cabinets to help control this movement, since they were notoriously bad at doing this themselves. The Detti series power amps however are fully compatible with every type of modern speaker cabinet. Big, small, sealed or ported. Complete control.
|input impedance||6.5 kohm|
|sensitivity||4 Vpp for full power output|
|frequency response||30 Hz to 18 kHz (-3dB)|
|Combined XLR and jack (un)balanced connector|
|supported impedances||2, 4 and 8 ohm|
|power||125 watt RMS @ 2, 4 and 8 ohm|
|Combined jack and speakon connectors|
|tubes||1x 12ax7 / ECC83, 1x 12au7 / ECC82, 4x KT88|
|mains voltage||110-120 VAC / 220-240 VAC selectable|
|dimensions||430 x 133 x 300 mm (W x H x D)|
|3HE (3 rackunits)|
|weight||13,2 kg (29.1 lbs)|
|Detachable rack ears for 19″ mounting included|